HP Netserver LXr 8000 Installation Guide

Chapter 7 Installing Additional Processors
67
Table 7-1. Processor Baseboard Configurations for 1 Through 4 Processors
Number of
Processors
Install Processor
in These Slots
Terminators
Required for
These Slots
Voltage Regulator
Modules Required
in These Slots
1
Proc 1 Proc 2
Proc 3
Proc 4
VRM 1 (Cache 1/2)
VRM 2 (Cache 3/4)
VRM 3 (Core 1)
2
Proc 1
Proc 2
Proc 3
Proc 4
VRM 1 (Cache 1/2)
VRM 2 (Cache 3/4)
VRM 3 (Core 1)
VRM 4 (Core 2)
3
Proc 1
Proc 2
Proc 3
Proc 4 VRM 1 (Cache 1/2)
VRM 2 (Cache 3/4)
VRM 3 (Core 1)
VRM 4 (Core 2)
VRM 5 (Core 3)
4
Proc 1
Proc 2
Proc 3
Proc 4
None VRM 1 (Cache 1/2)
VRM 2 (Cache 3/4)
VRM 3 (Core 1)
VRM 4 (Core 2)
VRM 5 (Core 3)
VRM 6 (Core 4)
2. Log off all users. Back-up files. Follow instructions in your network
operating system (NOS) documentation to gracefully shut down all
networking software and applications.
3. Press the power switch on the HP NetServer’s control panel when
prompted by the operating system. Normally, this is the complete
procedure.
NOTE The power supplies will continue to provide standby current to
the NetServer until the power cable is disconnected.
4. Disconnect the power cord and signal cables, and if necessary, label them
to support reassembly.