HP Netserver LXr 8000 PCI Hot Plug Replacement

Chapter 6 Addendum HP NetServer LXr 8000 Installation Guide
10
14. Align the board along its slot and position it in the slot.
15. Push the board down into its connector on the I/O baseboard.
Figure 6-6. Installing the Accessory Board
16. Insert the screw in the accessory board’s bracket and secure it to the HP NetServer’s rear panel.
See Figure 6-6.
17. If the installed accessory board requires a connection to the I/O baseboard, system board, or chassis, ensure
that the cable is properly attached.
Refer to the accessory board documentation for connection requirements.
18. If all desired accessory boards have been installed, re-install all covers.
CAUTION To prevent damage to cables, or a disruption in service due to a disconnection of cables, use
caution when sliding the chassis into the rack.
19. If chassis work is complete, slide it back into the rack. See Figure 6-7.
20. Use a T-25 screwdriver to screw the flanges to the rack front columns. See Figure 6-7.
21. Re-install the bezel onto the front of the NetServer.