HP Netserver LXr 8000 PCI Hot Plug Replacement

Chapter 6 Addendum HP NetServer LXr 8000 Installation Guide
24
Accessory
Board
Bracket
Figure 6-18. Replacing PCI Boards
6. Ensure the board is fully seated before continuing.
7. Insert the screw into the PCI board’s bracket and use the T-15 driver or Phillips screwdriver to secure it to the
rear panel. See Figure 6-18.
8. If the previous PCI board had a cable(s) attached to it, connect the cable(s) to the new board before
continuing.
9. Refer to the section in this chapter, "Powering Up the PCI Slot," to return power to the slot and verify the PCI
board’s operation.