HP Netserver LXr 8000 PCI Hot Plug Replacement

Chapter 6 Addendum HP NetServer LXr 8000 Installation Guide
7
5. At the front of the NetServer, extend the anti-tip foot out of the installation rack. See Figure 6-3.
6. Remove the bezel from the front of the NetServer.
7. Use a T-25 screwdriver to remove the screws holding the NetServer’s flanges to the rack front columns.
CAUTION To prevent damage to cables or a disruption in service due to a disconnection of cables, check for
short cables at the rear of NetServer and disconnect before proceeding.
8. Pull the NetServer out from the rack on its slides. See Figure 6-3.
Use anti-tip foot
Use handle to
pull out NetServer
Rack front columns
Flanges
Figure 6-3. Sliding Out the NetServer