HP Netserver LXr 8000 Rack Cabling Guide

Chapter 2 Connecting and Routing Cables to the HP NetServer LXr 8000

230/240V PDU Rack Power Configurations

Configurations for the 230/240 VAC, PDU options are shown in the text below,

Table

2-4, and Figure 2-9.

230/240 VAC Power Configuration

In a country with a 230/240 VAC power system, the high-voltage (230/240 V)

PDU model E7671A is required. If you are using a UPS, attach the C-19 end of

the accompanying power cord to the PDU and attach the C20 end of the same

cord to the IEC 320 receptacle in the rear of the UPS.

Alternate 230/240 VAC Power Configuration

When the 230/240 VAC PDU is to be used without a UPS in the rack, the PDU is

shipped with a localized power cord. For use with 230/240 VAC power mains,

direct connection to a junction box is usually necessary. In this case, an

unterminated power cord is supplied. Be sure to obey all local electrical code

requirements when connecting to the site electrical power supply.

Table 2-4. 230/240 VAC PDU Power and Current

Component

(Note 1)

Model Power

(VA)

Power

(W)

Current

(A)

Note 2

230/240 VAC PDU E7671A N/A N/A maximum

HP NetServer LXr

8000

D6021A (single 400 MHz

processor, 512K Cache)

D6022A (single 400 MHz

processor, 1 MB Cache)

1,121 1,077 4.9

HP NetServer

Rack Storage/8

D4902A 211 209 0.9

HP Console Switch J1497A 42 29 0.2

Note 1 More ratings are listed in Table 3-4. For a full list of power ratings, see the rack

configuration utilities (for instance, Rack Assistant) on the HP Web Site.

Note 2 Indicated current ratings are for use in selecting PDU and UPS components and

may not reflect actual measured amounts.