HP Netserver LXr 8000 to LXr 8500 Upgrade Guide

Chapter 5 Assembling the LXr 8500
42
Install the Midplane Board and Center Support
1b. Orient the midplane board so that:
- the notches point down
- the peripheral bay power connector
faces the front of the NetServer
1c. Angle the midplane as you insert
then fasten all four screws.it,
Figure 5-1. Install Midplane
1. Locate the LXr 8500 midplane board and install it as follows (see
Figure 5-1):
a. Move the peripheral bay cables out of the way.
b. Orient the midplane board so that the notches in the sheet metal point
down, and the peripheral bay power connector faces the front of the
NetServer.
c. Angle the midplane board as you insert it, then rotate it to the vertical
position. The three connectors on the midplane board line up with
openings in the sheet metal leading to the power supplies.
d. Fasten the four screws.