HP Netserver LXr 8000 to LXr 8500 Upgrade Guide

Chapter 5 Assembling the LXr 8500
52
11. Press the center of the
PCI hold-down latch in
Slot 2. Then swing
it back out of the way.
Figure 5-11. Open the PCI Hold-down Latch in Slot 2
11. Locate Slot 2 on the I/O baseboard (see Figure 5-8) and open the PCI
hold-down latch. (See Figure 5-11.)
12. Install the Remote Control
card in Slot 2.
13. The Remote Control
card cable passes over the
top of the slot dividers and
connects to J1F1 on the I/O
baseboard.
Figure 5-12. Install the Remote Control Card
12. Install the remote control card (RCC) in Slot 2. (See Figure 5-12.)
13. Connect the RCC cable to the connector labeled J1F1 on the I/O
baseboard.