HP Netserver Remote Administrator Guide

Chapter 3 Integrated RA Setup and Configuration
23
Configuring Communications/Modem
For Integrated RA to perform notifications and interact with administrators at
remote clients, you must configure it for communications by identifying the type
of data link, and, in the case of modem communications, you need to specify
modem and speed settings.
Figure 3-7. Connection Mode Window
To configure a data link:
1. Choose Configure Communications/Modem.
The Connection Mode Window appears providing two options.
à Direct Connection
à Modem Connection
Direct Connection
If you choose Direct Connection, you are prompted to verify COM port and
select port speed (at selected rates measured in bits-per-second). When you
choose port speed, be sure that the same speed is selected at both server and client.
Modem Connection
If you choose Modem Connection, the Configure Communications window
allows you select and configure a modem, including selection of COM port,
dialing method, and COM port speed (at selected standard bps rates).