HP Netserver Remote Administrator Guide

Chapter 3 Integrated RA Setup and Configuration
26
Table 3-1. Modem Commands Required by Integrated RA
Feature enabled Command
Result codes displayed Q0
Verbose result codes V1
Busy and dial tone detection X4
Auto answer S0=1
RTS/CTS (hardware) flow control &K3
DCD equals on-line state &C1
Disconnect on DTR On-to-Off &D2
Fixed DTE speed &Q5S36=7
Error correction &Q5
Configuring Administrators
Before an administrator can use Integrated RA to manage server operations from
remote sites, you need to supply Integrated RA with information it requires to
communicate with an administrator at a remote client. You can configure up to
eight administrator names for remote management.
The ability to specify multiple administrators allows you to provide back-up
administrators with access to the server through Integrated RA.
NOTE Remember that HP Integrated RA's software license authorizes
a single administrator for each copy of software (including
pcAnywhere).
Choose the Configure Administrators option from the Integrated RA Configuration
Utility menu to display the Administrator window.