HP Netserver Remote Administrator Guide

Chapter 5 Setting Up the Remote Client
53
• If you are using an HP-UX workstation as a remote client, see the section
"Connecting to Integrated RA from an HP-UX Workstation," later in this
chapter.
The remote client display will more closely resemble the actual server display if
you use a PC-based color ANSI terminal emulator that supports 25 lines and the
PC character set. The tables below provide the terminal settings and parameters
you should configure for using the Integrated RA.
Table 5-1. Terminal Emulation Settings
Setting Recommended Alternate
Emulation ANSI Color Monochrome ANSI/VT-100
Character Set Extended PC/IBM PC ANSI
Screen Dimensions 80 x 25 80 x 24
Line Wrap OFF
Local Echo OFF
Scroll ON
Carriage Return
Translation
None
Backspace Translation None
Cursor Underline, blinking
Table 5-2. Direct Connection Communications Parameters
Parameter Recommended Alternate
Baud Rate 38,400 See Configuration Utility
Data Bits 8
Stop Bits 1
Parity None
Handshaking None
Connect Assert DCD
Disconnect Drop DTR
Keyboard Mapping
If you are using a terminal emulator other than pcAnywhere, or a direct connection
to a terminal, you need to emulate the functions of special server keyboard keys
(for example, ESC, Home, and so on) via the terminal emulator. This emulation
can be accomplished by the mapping of ANSI escape sequences to the special
keys. Most terminal emulators permit the remapping of special keys to character