HP Netserver Service Handbook, Volume 3 - High-End

10
( c ) Terminator board must be installed when there is only 1 processor board in the system.
( d ) Early machines use several small single-slot panels.
( e ) This fan jumper must be installed on the system board.
( f ) Replace all A rev 64MB SIMMs with B rev parts.
( g ) This part number is constantly revised for each new release. When you order using this number you will
be sent the current revision of the CD-ROM.
( h ) Price list points from this part number to current part number.
( I ) Must install B1 plug on system board if any B1 CPUs in system.
Abbreviation Description
166-512 166MHz with 512K cache
200-512 200MHz with 512K cache
150-ohm Older SCSI cable impedance
90- Ohm New SCSI cable impedance
Common Tray An HP-standard drive mounting tray
DAC Disk Array Controller
Dove A color
FDD Flexible Disk Dive
Flint A color in the new color scheme
HDD Hard Disk Drive
I2C "I squared C" management bus
P6 Pentium Pro chip
PCA Printed Circuit Assembly
SIMM Single In-line Memory Module