HP Ultra/Wide SCSI 4 GB and 9 GB Hard Disk Drive

Chapter 3 Mount the Drive in the NetServer E 45
24
Power
Switch
Flexible Disk
Controller
Flexible Disk
CD-ROM
System Board
IDE1
IDE2
F5
D5
C33
C33
D5
F5
*
SCSI Card
PCI 1
Shelf 1
Shelf 2
Shelf 3
Shelf 4
Shelf 5
Shelf 6
*
Key
Available Connector
Engaged Connector
50-pin SCSI Cable
IDE CD-ROM Cable
Flexible Disk Cable
Built-in SCSI Terminator
For cabling options and connector locations, see the
Technical Reference Label inside your HP NetServer chassis.
Figure 3-1. NetServer E 45 Shelf Positions and Cabling Options
•
Use the guidelines in Table 3-1 to determine the proper location within
your HP NetServer E 45 to install your hard disk drive.
Table 3-1. Mass Storage Device Locations and SCSI ID Settings
Device Location SCSI Address
Standard Hard Drive
(in models that include
one)
Shelf 5 0 (default)
HP Accessory 4 GB
HD (D4910A)
Shelf 3, 4, 5 or 6 0, if it is the first hard drive; for
subsequent drives, use address 1, 2
or 3
HP Accessory 9 GB
HD (D4911A)
Shelf 3, 4, 5 or 6 0, if it is the first hard drive; for
subsequent drives, use address 1, 2
or 3
HP SureStore T4i Shelf 3 or 4 4 (default)
HP SureStore 8i,
5000i, 2000i
Shelf 3 or 4 2 (default)
(can be set to any unused address)
Standard SCSI
Controller
PCI 1 Slot 7