Installation Guide for Compaq Racks

Chapter 3 Installation
20
CAUTION Take care to not damage the ribbon cable that connects the
control panel to the NetServer.
5. Reinstall the control panel in the leftmost slots, and install and tighten the
screws.
To avoid damaging the ribbon cable, verify that the ribbon cable goes
completely back inside the NetServer before mounting the control panel.
NOTE There are two possible locations for the control panel. Only the
leftmost position is correct for Compaq rack installations.
M
o
u
n
t
i
ng Slots for Compaq racks (on left)
C
o
n
t
r
o
l
P
a
nel
M
o
u
n
ting Slots for HP racks (on right)
Figure 3-11. Relocate the Control Panel