Installation Guide for Compaq Racks

2Overview

The steps required to install the NetServer in the rack are summarized below:

NOTE This is only a summary; detailed instructions are provided on the

following pages.

• Measure and mark the appropriate holes on all four rack columns.

• Install one bar nut on each of the four rack columns.

• Insert two cage nuts on each of the two front columns only.

• Attach the slides to the columns.

• Extend the slides.

• Remove power supply modules and hot-swap drives from the NetServer.

• Lift the NetServer onto the slides.

• Secure the NetServer to the slides.

• Remove the lifting handles from the NetServer.

• Reinstall the power supply modules and hot-swap drives.

• Push the NetServer back into the rack enclosure.

• For HP NetServer LH 3000r and LH 6000r, attach the optional cable

management arm.

• Install the recessed mounting brackets on the two front columns only.

• Relocate the control panel.

• Install the Compaq rack-compatible bezel.