Installing Caldera eServer on an HP Netserver

Start: 21 (or lowest available number) End:277 (adjust to get about 256M)
System type: Swap
D. Click OK.
14. Create a root partition.
A. Click on sda3.
B. Click on Edit.
C. Set the parameters as follows:
Start: default End: use remaining space
System type: Linux Mount point: / Bootable: Format: Ö
set the partition size to the desired amount of space.
D. Click OK.
15. Click Write then Next to go to the next step.
16. At the Format partitions screen, click on Format chosen partitions. Click Next
after the partition are formatted.
17. At the Select Profile screen, choose the installation profile that best suit your need.
You can also customize the profiles by clicking on Refine Selection. Click Next.
18. Select and enter the root password. You also have to create a non privileged account.
You can use the default name provided, or pick your own. Set a password for that
user and click Add. Click Next.
19. At the Set Up Network screen, enter all the requested network information. You may
set the system to retrieve the information from a DHCP server or you may use static
IP. Click Next.
20. At the Set Up Boot Loader screen, check write master boot record. Click Next.
21. If you have a modem installed in your system, you can configure it at this time. Click
Next.
22. If you have a printer attached to your system, you can configure it at this time. Click
Next.