HP Netserver LXr Pro Configuration Guide

2
Navigator version G.01.00 or later
Operating System Microsoft Windows NT Server 4.0, Enterprise Edition or later
Service pack SP3 and TCP/IP patches.
SPU
Model HP NetServer LXr Pro Model 1
Clock speed 200 MHz.
No. of CPUs 2 – 4 (at least 2 are required)
BIOS version 1.00.09CD0L or later
CPU cache Any size
RAM 128 MB minimum. Must be HP.
No. of power supplies 3
Local storage Internal or external, using any controller. Must use HP disks. See
Local
Storage below.
I/O slots: P4, [P5] – Adaptec AHA-2944UW SCSI controller
P2 – Public LAN Network Interface card
P1 – Private LAN Network Interface card (HP D5013A)
All others - Any other plug-in cards.
Storage
Local
Physical drive location SPU internal drive bays or HP external drive cabinet (e.g., HP Rack
Storage/8)
Disk drives Must be HP
Controller SPU embedded controller or any controller (any number, manufacturer or
driver) in any available I/O slot. Certified configuration used embedded
SCSI B.
SCSI bus Any HP cables that meet SCSI specifications and any SCSI bus speed
Shared
Controller
Model Adaptec AHA-2944UW
Use with HP AutoRAID Model 12H (A3700 AZ) only.
No. of controllers 1 - 2
Firmware v1.32.1
Driver Aic78xx.sys (version 4.0 from Service Pack 3)
SPU I/O slot P4, [P5]
SCSI ID 6, 7
BIOS Configuration
options:
Host Adapter SCSI Termination: Automatic
Reset SCSI Bus at IC Initialization: Disabled
Host Adapter BIOS: Disabled
Cabinet
Model HP AutoRAID Model 12H (A3700 AZ)
Firmware Revision HP26 or HP32
No. of cabinets 1 - 2
Disk drives: Any supported AutoRAID disk