HP Netserver LH 3000 Rack Cabling Guide

Chapter 2 Rack Cabling References

Power Cables and Components Available

When components are installed in a rack, a power supply subsystem for the rack is

required. HP recommends the NetServer LH 3000r be connected as follows:

• connected to a Power Distribution Unit (PDU) -- see Figure 2-1

• through an Uninterruptible Power Supply (UPS) -- see Table 2-1

• to a properly protected branch circuit or circuits -- see "Site Preparation --

Circuit Breakers" in Chapter 1

NOTE A Redundant Switch is available for use between the UPS and

the branch circuit or between the PDU and the branch circuit.

More information is listed in Table 2-2 and in Appendix B.

Table 2-2 lists details of the cables, components, plugs and receptacles for the

rack power supply subsystems for the HP NetServer LH 3000r.

Table 2-1. UPS Models and Power Ratings

Uninterruptible Power Supplies

APC Model

Voltage

Power (VA)

Power (Watts)

NS3000RM3U

100/200 VAC 3000 2250

NS2200RM3U

100/120 VAC

2200 1600

NS3000RMT3U

200/208 VAC 3000 2250

NS2200RMI3U

230/240 VAC 2200 1600

NS3000RMI3U

230/240 VAC 3000 2250

Note 1. Ensure UPS Volt Amps rating is not exceeded. Add power in Volt Amps of each

component and connect no more than those the UPS supports.

Note 2. Also ensure UPS Wattage rating is not exceeded. Add power in Watts of each

component and connect no more than those the UPS supports.

Note 3. Consult American Power Conversion Corporation (APC) for information on 100

V UPS for Japan.