HP Netserver LH 3000 Rack Cabling Guide

Chapter 3 Procedure for Connecting and Routing Cables to the LH 3000r

NOTE The configuration in Figure 3-2 requires different power

system configurations at different voltages, as shown below:

Voltage Power System Requirements

100 2 PDUs, 3000 VA UPS

120 2 PDUs, 3000 VA UPS

200/208 1 PDU, 3000 VA UPS

230/230/240 1 PDU, 3000 VA UPS

For more information on data cabling with the Rack Storage/12FC, see the HP

Rack Storage/12 FC Installation Guide.

Attach Data Cables to the Server

1. Locate SCSI connections, label both ends of the SCSI cables, and connect

one end of each one to the server. Tighten captive screws on SCSI

connectors to secure the cable connector to the server connector.