HP Netserver LXr 8500 with XP256 Config Guide for Windows NT4.0 Clusters
1
HP NetServer LXr 8500
with
XP256 (Fibre Channel or SCSI)
Cluster Configuration Guide
08 February, 2000
Introduction
This document defines the supported HP NetServer LXr 8500 configurations with the XP256 and
Microsoft Cluster Server. These configurations minimize single points of failure (SPOF), provide
maximum availability, and have been certified by Hewlett-Packard or Microsoft. This guide is
prescriptive; it describes the configurations supported by HP. Any deviance to these configurations can
result in an inoperative cluster or an operating cluster with degraded performance, hidden SPOFs, etc.,
and therefore will not be supported by HP.
What’s Defined in a Cluster
• Cluster
• SPUs
• Local and Shared Storage
• Intra-cluster and Client LANs
• Shared Storage Cabling
Cluster
Type of SPUs HP NetServer LXr 8500
Each node must be the same model SPU, but may have different clocks
speeds, main memory sizes, cache sizes, and number of CPUs (2, 3, or 4).
Number of nodes 2
Shared Storage XP256 with FC or SCSI connections. See Shared Storage
below.
LANs:
Client LAN Any NIC that is HP and Microsoft approved. See Client LAN below.
Intra-cluster
(Heartbeat) LAN
HP D5013A with crossover cable. See Intra-cluster LAN below.
Power source Direct from power mains, power conditioner or uninterruptible power
supply (UPS) using any power conditioner or UPS.
System software:
Navigator version L.16.05 or later
Operating System Microsoft Windows NT Server 4.0, Enterprise Edition or later
Service pack SP5 or later