HP Netserver DiagTools v2.0 User Guide

Chapter 5 Error Message Reference
56
Code Description Recommended Action
test failed at port
XXXXh.
0611h FIFO data transfer
test failed at port
XXXXh.
Possible system board failure.
0612h Baud rate speed
test failed.
Possible system board failure. If the test is running on a 16650 UART, make sure
that the clock frequency selected in the menu matches the jumper settings on the
card.
0613h Infrared Register
test failed at port
XXXXh.
Possible system board failure.
0614h Infrared Interrupt
ID test failed at
port XXXXh.
Replace the system board
0615h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0616h Infrared Line Status
test failed at port
XXXXh.
Replace the system board
0617h Infrared Data
Transfer test failed
at port XXXXh.
The test indicates that the system board is not working properly. Contact your
support provider for more details.
0701h Parallel Port Test
Failed
Possible system board failure.
0702h IRQ Activation test
failed at port
XXXXh.
Possible system board failure.
0704h A register
Write/Read test
failed at port
XXXXh.
Possible system board failure.
0705h A register FIFO test
failed at port
XXXXh.
Possible system board failure.
0706h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0707h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0708h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0801h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0802h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0803h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0804h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0805h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0806h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0810h Speaker test failed Make sure the Speaker is properly connected. Run the test again. If it fails,
replace the drive. Replace the Speaker if it fails this test repeatedly.
0811h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0812h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.
0813h DiagTools Error Report error to HP Customer Care Center and get the latest version of DiagTools.