HP Netserver LXr Pro8 SCSI Extender

Chapter 2 Installing the SCSI Extender
17
Power-Up Procedure
1. Install the AC power cord (if it was removed).
2. Install the system cables (if they had been removed).
3. Turn the power interlock switch at the rear of the HP NetServer counter
clockwise to the locked position. When the switch is locked, the slot in
the middle of the switch is vertical (Figure 2-10). The system will now
power up.
NOTE The interlock switch locks the satellite chassis in place. As a
safety precaution, the server cannot power up unless this
switch is locked.
The HP NetServer
cannot start unless
the Power Interlock
Switch is in this position
Figure 2-10. The Power Interlock Switch
4. Turn on the monitor.