HP Netserver LXr Pro8 User Guide

Chapter 2 Controls, Indicators, and Ports
11
2. Press the DC power button on the HP NetServer's control panel. The
system now powers up.
DC Power
Figure 2-5. HP NetServer LXr Pro8 Control Panel
3. Turn on the monitor.
Power Down Procedure
1. Log off all users. Shut down all networking software and applications.
2. Press the DC power switch on the HP NetServer's control panel (Figure
2-5). Normally, this is the complete procedure.
3. If you’re powering down the HP NetServer to service it, unlock the power
interlock switch at the HP NetServer's rear by turning it clockwise (Figure
2-6). The switch also turns off DC power, if you did not already turn it off
at the front panel. (See Chapter 3 for more details on opening and closing
the HP NetServer chassis.)