HP Netserver LXr Pro8 User Guide

Chapter 3 Opening and Closing the

HP NetServer

Ejector Handles

Figure 3-3. Sliding Out the Satellite Chassis

Redocking the Satellite Chassis

1. When you finish servicing the HP NetServer, move to the front of the

server and unlatch all four power supplies. (If the front bezel is in place,

remove it. See "Removing and Replacing the Front Bezel."

2. At the rear, insert the satellite chassis. To do so, push in the release latch

for each slide (Figure 3-4). While holding the latches down, push the

satellite part-way onto the base, so that the latches can no longer engage.