Installation and configuration of the HP NetRAID, NetRAID-1 and NetRAID 3Si Adapters

Chapter 6 HP NetRAID Series Software
73
Step K. Install NOS and HP NetRAID Drivers
Install Network Operating System (if necessary)
If the NOS is not already installed on the HP NetServer, install it according to
the instructions you printed in Step J after you created the HP NetRAID drivers
diskette. Usually, the NOS is installed on a drive connected to the embedded
SCSI Channel A. However, the NOS can also be installed on a disk array.
Uninstall the Old Drivers (if necessary)
If you have an old version of the HP NetRAID drivers installed on your system,
you need to uninstall the old HP NetRAID drivers now. The table that follows
lists the names of the drivers that you must uninstall. For instructions on
uninstalling a driver, see the user guide for your operating system.
NOTE You do not need to uninstall old drivers if your NOS is SCO
UNIX or SCO UnixWare.
Network Operating System Old Drivers to Uninstall
Microsoft Windows NT mraidnt.sys
NetWare 3.1x Mega3_1x.dsk
NetWare 4.1x Mega4_xx.ham
Mega4_xx.ddi
Mega4xx.dsk
Mega4xx.ddi
NetWare ASPI Megaspi.dsk
Megaspi.ddi
Banyan VINES 6.x, 7.0 Driver.o
IBM OS/2 mraid.add
Install HP NetRAID Series Driver
Load the appropriate driver as instructed in the Network Operating System
Installation Instructions that you just printed in Step J earlier in this chapter.