Installing SuSE on an HP Netserver

B. Select /dev/sda then click OK.
C. Select primary partition then click OK.
D. Set the parameters as follows:
Start: 1 End:+20M Mount point: /boot
lFormat lData with Ext2
Then click OK.
9. Create a swap partition.
A. Click Create.
B. Select /dev/sda then click OK.
C. Select primary partition then click OK.
D. Set the parameters as follows:
Start: default End:+256M Mount point:
lFormat lSwap
Then click OK.
10. Create a root partition.
A. Click Create.
B. Select /dev/sda then click OK.
C. Select primary partition then click OK.
D. Set the parameters as follows:
Start: default End: default Mount point: /
lFormat lData with Ext2
Click OK. Click Next.
11. At the Software selection screen, select the software package that suits your need.
You can customize the preset packages by clicking on Detailed selection. Create a
root partition. Click Next.