hp netserver lh 6000 netraid-2m config guide - for Microsoft NT 4.0 Clusters PDF, 240K, 2/23/2002

lh6000nt2m
2/23/02 2
Server Configuration
Parameter Specification
I/O slots Added cards may be installed in any appropriate slot, considering the server
default boot order provided below.
Default boot order
IDE CD-ROM, FDD, SE SCSI C, Embedded A, Embedded B, PCI64-8, PCI64-7,
PCI64-6, PCI64-5, PCI64-4, PCI64-3, PCI64-2, PCI64-1
Local Storage
Controller Embedded SCSI, embedded DAC, NetRAID-1M, or
NetRAID-2M (in addition to shared storage NetRAID-2M controller)
Driver For embedded SCSI, sym_u3.sys, version 5.05.00, or later
For embedded DAC, NetRAID-1M or NetRAID-2M, mraidnt.sys, version 4.05
(all drivers obtained from Navigator CD-ROM, version L.20.00, or later)
Physical drive location Server internal drive bays, or HP external drive cabinet
(e.g., HP Rack Storage/12)
Disk drives Must be HP
SCSI bus Any HP cables that meet SCSI specifications, and any SCSI bus speed
SCSI IDs Any
System software
Navigator CD-ROM Version M.04.00, or later
Operating system
Service pack
Microsoft Window NT

Server 4.0, Enterprise Edition
SP5 or
SP6a and Microsoft

hotfix Q316743.
Please refer to the Microsoft

product support article at:
http://support.microsoft.com/default.aspx?scid=KB;EN-
US;q316743&ID=KB;EN-US;q316743
Power distribution
Layout Redundant power distribution units (PDUs) are recommended. See power cabling
diagram on page 6.
Shared Storage Configuration
Parameter Specification
Controller
Model HP NetRAID-2M Controller, Model P3411A, or P3475A
Number of controllers One or two
BIOS Disabled
Firmware Version H.01.08
(firmware obtained from Navigator CD-ROM, version M.04.00, or later)
Driver Mraidnt.sys, version 4.05
(driver obtained from Navigator CD-ROM, version L.20.00, or later)
NetRAID Assistant Version B.01.04, or later
(software obtained from Navigator CD-ROM, version L.20.00, or later)
SCSI ID 6, 7
Channels 0, 1
RAID levels 1, 5, 10, 50
Logical disks One per RAID array
Eight, maximum, per cluster