HP Netserver LH 4r Installation Road Map

Install All Accessory Boards
1. Remove cover 1
2. Read the documentation
3. Remove the slot cover
4. Install the board:
5. Replace the cover(s):
as described in panel 4, "Removing and
Replacing the Covers."
included with each accessory
board. Follow any special instructions and installation
recommendations. Some boards have preferred slot locations. If a
board does not, consider the boot order (see below) when
choosing the accessory board socket in which to install the board.
for each slot to be used, and store it
for future use. If you are installing any full-length PCI boards, also
remove the accessory board retainer (see figure at right). Push on
the button on the retainer to release it, and then slide it out of the
board guide.
Insert each board in the desired slot and
fasten the board's mounting screw at the slot opening at the rear of
the chassis. Connect any required cables to each adapter board. If
you removed the board retainer, reinstall it.
If you are not installing any other
accessories, replace the cover(s) as described in panel 4,
"Removing and Replacing the Covers."
NOTE If you install an ISA non-Plug-and-Play board,
you must reserve system resources (some or
all of: memory addresses, I/O addresses,
IRQs, and DMA channels) for it. Note jumper
settings on the board and write down that
information for reference when you reserve
system resources in panel 12, "Configure the
HP NetServer."
An accessory board can be identified by the offset of the bracket
and the shape of the edge connector:
PCI Board- Left-Side Offset
ISA Board- Right-Side Offset
NOTE For a list of boards HP has tested, see Help topic
"Tested Parts List" on the
.
HP NetServer Navigator
CD-ROM
Boot Device Priority
Boot order for PCI controllers is determined by slot location. The
system searches for a bootable device in the following order:
1. IDE CD-ROM drive with a bootable CD-ROM.
2. Flexible disk drive with a bootable flexible disk.
3. Embedded SCSI controller or embedded DAC.
4. PCI boards in slots in the following order: 8, 7, 6, 5, 4, 3, 2, 1.
This boot order can be changed using the SETUP utility (press [F2]
during the boot process).
Slot 1 16-bit ISA or 32-bit PCI
Slot 2 32-bit PCI
Slot 3 32-bit PCI
Slot 4 32-bit PCI
Slot 5 32-bit PCI
Slot 6 32-bit PCI
Slot 7 64-bit PCI
Slot 8 64-bit PCI
Accessory Board
Retainer
Accessory Board
Guide
Release Tab
Replace Covers
7
Replace all covers as described in panel 4, "Removing and
Replacing the Covers."
CAUTION Replace all covers before operating the NetServer,
even for a short time. Otherwise, damage to system
components may result due to improper cooling air
flow.
WARNING Do not attempt to lift this NetServer alone. Get
assistance before installing it in the rack.
8
Install the NetServer in the Rack
1. Remove the Power Supplies:
2. Install the NetServer in the Rack:
3. Reinstall the power supply modules:
Unscrew the thumbscrews
holding the two power supplies in the rear of the chassis and remove
them.
Refer to the
for instructions.
After installing the
HP NetServer in the rack, reinstall the power supply modules. When
the NetServer is installed in the rack, resume with panel 9 of this road
map, "Install Additional Mass Storage Devices."
HP NetServer
LH 4/LH 4r User Guide
6