HP Netserver LP 2000r User Guide

Appendix A Specifications
121
Table A-4. HP Netserver Hardware Specifications
Processors
Intel Pentium III (up to 2 processors) processors, at supported
speeds of 866, 933 MHz; and 1 GHz, with 256 KB level 2
cache on processor.
Chipset
Serverworks LE chip set with 133 MHz bus speed support.
Memory
Supports up to four SDRAM DIMMS (168 pin) for a
maximum of 4 GB. Supported DIMM types: 128 MB, 256
MB, 512 MB and 1 GB, PC 133 running at 133 MHz, 72 bits
wide, ECC single-bit correcting, multi-bit detecting.
Video
Embedded ATI Rage XL chip video with 4 MB
SGRAM/SDRAM. Supports up to 1600x1200, @ 65K colors,
with onboard standard video connector. Refer to Table A-5,
"Video Display Modes" for more details.
SCSI
Embedded Symbios Ultra-3 SCSI dual channel controller;
Ultra 160 MB/s transfer rate with two 68-pin connectors.
IDE
Embedded Enhanced-IDE dual channel controller.
LAN
Two Embedded Intel 82559 10/100 PCI Fast Ethernet
Controllers with onboard standard LAN connectors ( LAN
Power On/Off and Wake on LAN is enabled or disabled on
LAN A via BIOS setup).
PCI Bus
Three 32/64-bit, 33 MHz speed, 5 volt PCI slots on riser board
within PCI card cage.
I/O
Two Serial ports (including one Management/Serial) and one
bi-directional parallel port with ECP/EPP high-speed support;
one PS/2 mouse, one PS/2 keyboard, and two USB connectors.
CD-ROM
One standard CD-ROM drive; IDE interface; 48x speed.