HP Netserver LP 2000r User Guide

9
2 Opening and Closing the HP
Netserver
Introduction
This chapter describes how to the remove the front bezel, top cover, and air flow
guide from the HP Netserver LP 2000r.
WARNING Before removing the cover, always disconnect the power cord
and unplug cables. Disconnect the power cord to avoid
exposure to high energy levels that may cause burns when
parts are short-circuited by metal objects such as tools or
jewelry. Disconnect cables to avoid exposure to shock hazard.
Removing the Front Bezel
You need to remove the front bezel in order to install mass storage devices or
media. You do not need to turn off power to remove the front bezel.
1. Hold the bezel at the opening in the center and pull towards you to release
the top edge of the bezel.
The bezel rests on two pins and is held in place by spring latches at the top.
It rotates down to an 80
° angle.
2. Lift the bezel out toward you to remove it from the chassis. See Figure 2-1.
Pin
Pin
A
B
Figure 2-1. Removing the Front Bezel