HP Netserver LP 2000r User Guide
Chapter 4 Installing Additional Memory
31
5. Remove the air flow guide. See Figure 4-1.
Refer to "Removing the Air Flow Guide" in Chapter 2, "Opening and
Closing the HP Netserver."
Figure 4-1. Removing the Air Flow Guide
6. Locate the DIMM slots on the system board, and choose an empty slot to
install a DIMM. See Figure 4-2.
DIMMs may be installed in any combination, in any slot, but HP
recommends starting at slot 0 and filling the slots in order, with the largest
size first.
CAUTION Use only HP PC133 (133 MHz) SDRAM DIMMs.