HP Netserver LP 2000r User Guide

55
7 Rack Mounting the HP Netserver
(4-Post)
Introduction
This chapter provides instructions for mounting the HP Netserver in 4-post HP
System/E or System/U racks (shown in Figure 7-1) and third-party non-threaded
4-post racks. If you have the older 4-post HP Systems rack, see Chapter 13,
"Alternative Rack Mounting," for instructions. If you have a 2-post non-HP rack,
see Chapter 8, "Rack Mounting the HP Netserver (2-Post)," or refer to the
documentation in the appropriate rack accessory kit. If you want to install the HP
Netserver in a third-party rack not covered in this guide, you may find relevant
documentation on HP’s web site at the following URL:
http://www.hp.com/netserver/support
a
b
d
e
c
Characteristics of
System E and
Sustem U racks:
a. 5-Cornered Columns
b. Full Panel Vent
c. “HP Rack System/E” or
“HP Rack System/U”
Nameplate.
d. Numbered EIA Units
e. Anti-tip Foot extends
Figure 7-1. HP System/E and System/U Rack Features
The HP Netserver LP 2000r rack mount kit requires two EIA units of space in the
rack. Before mounting the Netserver, plan the Netserver’s location in the rack
relative to other rack components. Proper placement is vital both for safety and