HP Netserver LP 2000r User Guide

67
8 Rack Mounting the HP Netserver
(2-Post)
Introduction
This chapter provides instructions for mounting the HP Netserver in a two-post
non-HP rack. The illustration below shows the characteristics of the 2-post
(CPI – Chatsworth Products Inc.) rack.
If you have the 4-post HP System/E or System/U rack, or a third-party 4-post
rack, see Chapter 7, "Rack Mounting the HP Netserver (4-Post)," for instructions.
If you have the older 4-post HP systems rack, see Chapter 13, "Alternative Rack
Mounting." If you want to install the HP Netserver in a third-party rack not
covered in this guide, you may find relevant documentation on HP's web site at
the following URL:
http://www.hp.com/netserver/support
Characteristics of
2-Post Rack:
A. U-shaped column for easy
access
C. Base is bolted to floor.
B. Top is secured to
ceiling to hold
additional weight.
A
B
C
Figure 8-1. Features of 2-Post Rack
The HP Netserver LP 2000r rack mount kit requires two EIA units of space in the
rack. Before mounting the Netserver, plan the Netserver's location in the rack
relative to other rack components. Proper placement is vital both for safety and