HP Netserver LP 2000r User Guide

Chapter 8 Rack Mounting the HP Netserver (2-Post)

Marking the Columns

To make it easier to mount the HP Netserver in the rack, you may want to mark

the column holes that will be used by the Netserver. The Netserver may be

mounted using either flush-mount or center-mount brackets that attach to the front

side of the two columns. Use a marking pen or masking tape to mark the columns.

Use the HP Rack Configuration Tools to determine where in the rack to mount the

HP Netserver. The tools are available at:

http://www.hp.com/netserver/support

1. Use the marking pen or masking tape to mark the server position on the

front of both columns. See Figure 8-2.

The two brackets are mounted at the 1st and 5th holes on the columns,

relative to the bottom of the HP Netserver.

5th Hole

From Bottom

2nd Hole

From Bottom

Mark this face of

the columns with

masking tape

or marker pen.

Right

Side

Left

Side

Front of

Rack

Bottom of

HP NetServer

Masking

Tape or

Marker

Figure 8-2. Location Marks on the Rack’s Front Columns