HP Netserver LP 2000r User Guide

Chapter 10 Configuring the HP Netserver

one must be enable in the Netserver’s (BIOS) Setup Utility under

Embedded LAN Controllers in the LAN A submenu (Configuration >

Embedded LAN Controllers > LAN A).

You must also install the Netserver Agent software from the HP Netserver

Navigator CD, and the AOL2 client software. Refer to the Netserver Alert

On LAN 2 User Guide available online on the HP Netserver Online

Documentation CD-ROM included with your system.

DiagTools

This utility provides an easy-to-use hardware diagnostic for Netserver verification,

burn-in, and rapid troubleshooting. It must first be copied to diskettes and then

executed from the diskettes.

NOTE HP recommends using the HP DiagTools utility to verify all

Netserver functions are operating correctly, after completing all

the configuration topics. The HP DiagTools utility also

generates a text file containing the hardware detected and the

DiagTools test results. This text file, called a support ticket,

should be saved to a diskette and used for future reference,

especially by your support provider.

Setup (BIOS) Utility

The HP Netserver (BIOS) Setup Utility is used to configure the following

Netserver options:

• User Preferences

• Security

• Configuration

• Exit

Accessing the Setup Utility

The (BIOS) Setup Utility menu offers the choices listed above, and the

corresponding items are described in the topics below.

1. Turn on the monitor and the HP Netserver.

2. Start the Setup Utility by pressing the [F2] key, when the following

message appears on the boot screen.

Press <F2> to enter SETUP