HP Netserver LT 6000r Installation Guide

Chapter 10 Configuring the HP NetServer
113
Figure 10-2. System Board Configuration Switch
3. Close the system board access panel and power on the server.
4. Let the server boot.
5. After booting, shut down and power off the server and open the system
board access panel.
6. Reset Switch 5 from the ON position to OFF.
7. Close the system board access panel and power on the server.
SCSI Configuration Utility
NOTE The Symbios Configuration Utility is not available if you leave
the NetRAID default (enabled) unchanged. It is only available
for LVD SCSI mode.
If you need to verify or modify SCSI host adapter settings or if you need low-level
format SCSI disks or verify SCSI disk media, run the Symbios Configuration
Utility:
1. Power on or reboot the server.
2. During system start-up or reset, simultaneously press [Ctrl] and [C] when
the following message appears:
Press [Ctrl] [C] to start Symbios Configuration
Utility