HP Netserver LT 6000r Installation Guide

Chapter 13 Alternative Rack Mounting
134
Step 1: Mark the LT 6000r’s Position in the Rack
Use the rack-mount template to mark out four EIA units for positioning the
LT 6000r in the rack.
NOTE Use the HP Rack Assistant software to determine where to
mount the HP NetServer in the rack.
CAUTION Be sure to compensate for any other components that might be
mounted in the rack. Install these components before
mounting the LT 6000r.
1. Pull the anti-tip foot out of the bottom of the rack.
Figure 13-2. Anti-Tip Foot