HP Netserver LT 6000r Installation Guide

Chapter 4 Installing Mass Storage Devices
40
Installing Hot-Swap Drives
1. Slowly slide the drive into the hot-swap cage (Figure 4-6) until it seats into
its connector.
CAUTION Be careful not to damage the light pipes as you insert the
drive. They are very fragile.
Figure 4-6. Installing a Drive into the Hot-Swap Cage
2. Press in the ejector handle until you feel the locking latch click into place.
Closing the ejector handle engages the drive with the electrical connector
in the hot-swap cage.
3. If the drive is unseated in the cage after closing the ejector handle, the
handle was probably not pulled out far enough, and the locking latch failed
to engage the connector. Repeat from Step 2.