HP Netserver LT 6000r Installation Guide

Chapter 6 Installing Additional Boards
50
Figure 6-2. PCI Accessory Board Slots
The I/O baseboard consists of the following components:
Six PCI accessory board slots
PCI slot Hot-Plug LEDs
I
2
O memory slot, which contain cache memory DIMM used by the
embedded RAID controller (Intel i960RN I/O processor); which is 64 MB
standard and can be upgraded to 128 MB.
Guidelines
When installing accessory boards in the HP NetServer LT 6000r, observe the
following guidelines:
WARNING Never add or remove a PCI accessory board when the PCI
slot’s green power LED is on.
WARNING Do not attempt to install or remove PCI accessory boards
when the NetServer is in a sleep state. Doing so will crash the
system.