HP Netserver LT 6000r Installation Guide

Chapter 6 Installing Additional Boards

Figure 6-3. Removing the PCI Slot Cover

(Locking Levers and Retainers Shown)

8. Before installing an accessory board:

◊ Verify that there is no extender attached to it, especially if it is a

full-length board.

◊ If the board has a extender attached to it, remove the extender before

installing the board.

9. Align the full length of the board with its slot and position it into the slot.

NOTE For instructions on installing a PCI accessory board in Slot 1,

see the subsection "Installing an Accessory Board into Slot 1."

CAUTION Do not bend the accessory board when installing it.

All accessory boards are held in place with the PCI lever and

retainer. Full-size boards are supported when seated in the

card guides.