HP Netserver LT 6000r Installation Guide

Chapter 6 Installing Additional Boards
59
NOTE For Case 1 (from Table 6-1), the NetServer can remain
installed in the rack. For Cases 2 and 3, the NetServer must be
removed from the rack, and you must remove both slides from
the chassis before you can open the access panel.
NOTE It is recommended to remove the NetServer from the rack
before installing a full-size accessory board in the accessory
board tray.
NOTE Read label on accessory board access panel before installing
the board.
Read label before
installing accessory
board.
Figure 6-5. Inserting the Accessory Board into Tray
(Half-Size, Half-Height Board Shown)