HP Netserver LT 6000r Installation Guide

Chapter 7 Installing Additional Processors
69
CAUTION Do not remove the processor from its bag until you are ready
to install it. Make sure that the bag remains sealed.
Shutdown and Power Off the NetServer
1. Log off users and shut down the NetServer according to your NOS
instructions.
2. Power off the NetServer.
3. Disconnect the power cord and cables from the NetServer’s rear panel and
label them for reassembly.
CAUTION The power supplies will continue to provide standby current to
the NetServer until the power cable is disconnected.
Remove the System Board Assembly
1. Open the system board access panel according to the instructions in
Chapter 3, Opening and Closing the HP NetServer.
NOTE If the NetServer is in a rack, slide it out before opening the
access panel. Be sure to pull out the rack’s anti-tip foot to keep
the rack from tipping over.
2. Remove the system board by sliding the release latches in the direction
shown in Figure 7-2 (on the next page). This unlocks the system board
from the access panel.