HP Netserver LT 6000r Installation Guide

Chapter 8 Mounting the HP NetServer in an HP Rack System/E or Rack System/U
82
1. Loosen the adjustment knob on one slide, insert the rear rack pins into the
appropriate holes on the outside rear column, and hold into position.
2. While holding the slide in the rack, extend the front bracket forward to the
outside front column using the grip on the slide, and insert the front rack
pins into the holes that you marked with the template. See Figure 8-4.
Figure 8-4. Insert Rack Pins into Rack
3. With both sets of rack pins in position, release the slide so that the tension
spring seats the slide into the rack.
4. Tighten the adjustment knob so that the slide is secure, and will not unseat
itself when mounting the NetServer on the slides.
5. Repeat Steps 1 through 4 to install the other slide.