HP Netserver LXr 8500 Rack Cabling Guide

Chapter 3 Procedure for Connecting and Routing Cables to the LXr 8500

B. Plug power and data

cables into the back of

the Server

F. Drape

cables

through

the fingers

of the

Cable

Guide

A. Begin with

the Server all

the way in

D. Arrange cables

through the inner

section of the arm,

around the elbow,

and through the

outer section

C. Gather

cables at left

and tie to

Cable

Management

Arm flange

E. Tie wrap cables into the inner

and outer sections of the Arm

Figure 3-9. Routing Cables through the Arm

2. Arrange cables through the slot on the inner section of the Arm. Secure

cables in the cable arm using the hook-and-loop cables supplied with the

NetServer.

3. With the cable arm still in the unextended position, place cables in the

outer section of the arm and secure them with cable ties. Drape the cables

through the fingers of the Cable Guide but do not secure them yet.

4. Prepare to extend the NetServer from the front of the rack by removing the

front bezel and extending the anti-tip foot.