HP Netserver LH Pro Surestore E Installation Guide

11
Install Controller Modules
CAUTION Before installing a controller module, ensure that all of the pins on the controller
connector are straight. Bent pins will cause the controller module to fail, and the array
will not function properly. Also, do not attempt to install the controller module upside-
down.
1. Pull the controller module levers all the way out.
2. Insert the controller module into the disk array, while pushing on both sides of the controller module.
3. When the enclosure engages the levers, press the center of the levers with the palm of your hand until
they lock securely into place. You should hear an audible click when the levers lock.
Figure 6. Installing Controller Modules