HP Netserver LP 1000r Installation Sheet

Installing a second Processor
(Continued)
Thumb Latch
Hook Latch
(hidden)
Tab
Step A
Lower Heat
Sink
Processor
Socket
Tab
CAUTION) Ensure the left ridge on the bottom of the heatsink fits  
  into the grove between the processor socket and  
  processor, while both ridges straddle the processor. If  
  good contact is not made the processor can overheat  
  and possible damage may occur.
Hold Down
Ridges
Hook Latch
Step B
Hook Latch
Step C
Thumb
Latch
Thumb
Latch
CAUTION) To prevent scratching off some of the thermal material, 
  do not slide the heatsink around once it is on the  
  processor. Rocking it slightly to install both sides of the 
  latch is acceptable.
Tool Latch
Remove
Heat Sink
Installing a Second Processor
CAUTION) Do not open the new processor's protective bag or  
  remove it from the bag until you are ready to install it.
  Always wear a wrist-strap and use a static-dissipating  
  work surface connected to the chassis when handling  
  components. Ensure the metal of the wrist strap contacts 
  your skin.
  Before you remove a processor from the anti-static  
  bag, touch a grounded, unpainted metal surface on  
  the HP Netserver to discharge static electricity.
Terminator
ZIF
Lever
Processor
Socket
NOTE) ) No speed switch settings are required for the supported 
  processors (866, 933 MHz, or 1 GHz) in the
  HP Netserver. These processors rely on the internal  
  settings within the processors and do not rely on external 
  switch settings on the system board.
NOTE) Retain the terminator for future use. The Netserver will 
  not operate properly if using only one processor with no 
  terminator installed.
Pin-1
Marker
CAUTION) The heatsinks are not reusable, unless the thermal patch 
  has been replaced each time the heatsink is removed,  
  even if the heatsink is just temporarily removed from a  
  processor and then re-installed on the same processor.
  Each time the heatsink is removed from the processor, 
  some of the thermal material is removed from the patch.
NOTE) If you are re-installing a heatsink on the processor, you 
  may need to scrap off any thermal material left on top of 
  the processor chip. Use your fingernail to scrap off the  
  material, but ensure you are grounded with a
  static-dissipating wrist strap.
CAUTION) To prevent overheating and possible damage to the  
  processor, inspect the thermal patch to ensure the  
  thermal material covers the whole patch. If not, you must 
  remove the old patch and replace it with a new thermal 
  patch.