HP Netserver LXr 8500 NetRAID-4M Config Guide for Windows NT4.0 Clusters

2
supply (UPS) using any power conditioner or UPS. Redundant power
distribution units (PDU’s) are strongly recommended.
System software:
Navigator version L.20.00 or later
Operating System
Service Pack
Microsoft Windows NT

Server 4.0 Enterprise Edition
SP6a
SPU
Model HP NetServer LXr 8500
Clock speed 700 MHz
No. of CPUs 2 – 8
BIOS version ASPN Release 8
CPU cache Any size
RAM 128 MB minimum. Must be HP.
No. of power supplies 3
Local storage See Local Storage below.
I/O slots Added cards may be installed in any appropriate slot, keeping in mind the
server’s default boot order as listed below:
Default Boot Order IDE CD-ROM, FDD, PCI-1, PCI-2, SCSI A, SCSI B, PCI-3, PCI-4, PCI-5
through PCI-10
Microsoft

and HP
Certified
Configuration
P3 – Intra-cluster (Heartbeat) LAN – D5013B
P4 – Client LAN – D5013B
P5 – Local storage –NetRAID-1Si
P7 – Shared storage – NetRAID-4M
Booted from NetRAID-1Si
Storage
Local
Controller May use embedded SCSI, NetRAID-1Si, NetRAID-3Si, NetRAID-1M or
NetRAID-2M.
Driver For embedded SCSI, use sym_hi.sys 4.12 or later.
For NetRAID-xSi, use mraidnt.sys version 4.05.
For NetRAID-1M/2M, use mraid2k.sys, version 4.05.
All are from Navigator L.20.00 or later.
Physical drive location SPU internal drive bays or HP external drive cabinet (e.g., HP Rack
Storage/12)
Disk drives Must be HP
SCSI bus Any HP cables that meet SCSI specifications and any SCSI bus speed
SCSI Ids Any
Shared
Controller
Model HP NetRAID-4M Adapter D9161A or D9351A
No. of controllers 2 maximum
BIOS
Disabled
Firmware 4584
Driver Hpn.sys version 2.4.0.4571