HP Netserver LH 3/LH 3r Processor Upgrade Guide

Chapter 1 Processor Module Installation
12
Removing the Terminator Board
If your system has one processor, a terminator board is installed in the upper slot.
You must remove the terminator board before installing a processor module into
this slot. (See Figure 1-10).
1. Squeeze together the two retaining latches on the terminator board.
2. Pull the terminator board out of the socket.
Save the terminator board for future use.
Terminator Board
Terminator Board
Retaining Latches
Figure 1-10. Removing the Terminator Board