HP Netserver LH 3/LH 3r Processor Upgrade Guide

Chapter 1 Processor Module Installation
13
Removing the Processor Module
If you are upgrading an existing processor module, you must first remove the
module from the slot.
To remove a processor module:
1. Press in on each processor module release latch until it remains in (see
Figure 1-11). If the latch does not stay in, you must hold it in while
removing the module.
2. Lift up on the processor ejector lever until the processor pops out of the
processor socket (see Figure 1-11).
CAUTION Do not move the processor ejector lever beyond its limit
(about 25-30 degree angle from horizontal). The ejector lever
may break if forced.
3. Remove the processor module from the mounting bracket assembly.