HP Netserver LH 3/LH 3r Processor Upgrade Guide

Chapter 1 Processor Module Installation

Completing the Installation

Complete the processor module installation by installing the system board,

covers, and bezel.

CAUTION Never operate this NetServer without first installing all

covers and the front bezel. Operating the system without all

covers in place reduces critical cooling airflow over some

components, such as hard disk drives and processor modules.

Operating the system without all covers in place may result in

failure of these components.

Separate procedures follow to complete installation for the HP NetServer LH 3

and the HP NetServer LH 3r.

Completing the HP NetServer LH 3 Installation

To complete the installation:

CAUTION Replace all covers before operating the HP NetServer, even

for a short time. Otherwise, damage to system components

can result due to improper cooling flow.

1. Install cover 3 by inserting the cover tabs into slots on the chassis. Slide

the cover toward the rear of the chassis and tighten the thumbscrew.

2. Install the bezel.

3. Confirm that all cables are attached firmly.

4. Power up the system and verify that the system fan and processor fan are

operating.

Proceed to the section "Updating the BIOS" later in this chapter.