HP Netserver LH 3/LH 3r Processor Upgrade Guide

Chapter 1 Processor Module Installation

Completing the HP NetServer LH 3r Installation

To complete the installation:

1. Insert the system board into the plastic guides in the chassis. Hold the

retaining latches vertically while inserting the board until it touches its

socket on the backplane. Lower the retaining latches until they are

horizontal, and the system board is seated firmly in its slot.

CAUTION Replace all covers before operating the HP NetServer, even

for a short time. Otherwise, damage to system components

can result due to improper cooling flow.

2. Replace cover 2 by holding the cover over the side of the chassis. Slide the

cover up to insert the cover tabs into slots on the chassis. Slide the cover

to the rear of the chassis and tighten the thumbscrew.

3. Depress the lockout releases, and push the unit completely into the rack

(see Figure 1-14).

Figure 1-14. Location of Lockout Releases